Linksys Network Card EC2T User Manual

™

M a k i n g Co n n e c t i v i t y Ea s i e r

Quick Installation

This sheet will guide you through the basic steps needed to install this

Linksys product on your computer. If you have any problems during

installation, visit our Windows 2000 support page at www.Linksys.com.

Instant Ethernet^®

For Windows 2000

Combo Ethernet LAN Card

Model No.: EC2T (w/ hourglass coupler)

After physically installing the Ethernet LAN Card in your com-

puter, follow these instructions to install the network driver.

5. In the Hardware tab, click on the Device Manager button.

1. Start your computer and boot up Windows 2000.

Windows 2000 will automatically configure the Ethernet

LAN Card Driver for your PC using the built-in driver.

When the Windows Desktop is displayed, you can now

check to make sure that the driver is properly installed.

2. Click on the Start button, then Settings, then Control

Panel.

6. In the Device Manager window, click the “+” next to the

Network Adapters listing.

3. When you are in the Control Panel, double-click on the

System icon.

4. When the System Properties box is displayed, click on the

Hardware tab.

7. After you confirm that Linksys Combo PCMCIA Ethernet

Card is listed, close the window.

Installation is complete.

If you want to share files or printers,

refer to the Windows 2000 manual or visit our

Note: Do not click Cancel or Skip at

any time during the installation process.

Doing so will prevent your driver from

being properly installed on your PC.